1), determine the correct machine paper folding, please press the page order manual fold a folding sample folding sample generally take half of the paper width, (paper fold the crease in the middle of the paper table) loosen the handle, the file on the paper table paper gauge and file stick are adjusted to the paper edge by tightening the handle.
2) Determine the direction of the paper according to the folding sample.(Usually, the printed plate head is the gauge position of the folding paper)
3) Organize the paper to facilitate the smooth work of flying da.(Shake paper excluded because of static electricity, ink and other factors caused by the adsorption of the paper, finishing the paper head to prevent the paper due to damp, deformation and other phenomena into the fence or roll Angle, the arranged paper neatly stacked on the paper table.）
3) after the paper (confirm the selection switch in the corresponding function position) press the paper table rise start button, the paper table rose to a certain height under the action of electric eye monitoring automatically to slow rise and to adjust the working position of the fly at the height of the detection pole and press the edge of the paper will automatically adjust the working height of the paper separator.
4) Release the star screw knob, push the paper positioning plate to the outer side of the paper, close to the paper edge and then tighten the star screw knob. At the same time, adjust the number and position of the paper pressing rod required on the bridge to ensure the stability of the paper process.
5) Select the number and orientation of the fence board according to the folding mode of the folding sample. Adjust the gauge position of the fence panel according to the required size of the finished product, loosen the knob on the outside of the adjustment disc and adjust it until the sample size.
6) fold the folded paper to the paper, and press the pressure support of the folding roller, that is, the pressure plate under the adjustment knob. Under normal circumstances, put the corresponding paper into the pressure plate under each pressure support according to the thickness of the paper through each set of folding roller.
7) According to the needs of binding and folding mode, choose the punching knife, indentation knife, the cutting knife first press the emergency stop button to shake the transmission hand wheel and loosen the tool wheel on the tool shaft to close to the blade wheel above and tighten the tool wheel.(The number of blade teeth; whether the blade is sharp and effective; the direction of the blade cannot be reversed)
8) The working position of the adjustable electric eye and the working frequency of the electronic knife. According to the working detection position of the paper through the working detection range of the electric eye and adjust the frequency of the pull switch (or select the three gears of fast / medium / slow), the folded paper can be successfully brought into the next folding link by the electric control knife action.
9) Adjust the operating parameters of various machines and leaflets in the touch screen.
10) Adjust the double detection mechanism so that a piece of paper can pass smoothly and the double sheet can not pass.
11) start host machine normal turn, start the fan, fine-tuning feida height and blowing, nozzle, the length of the brush or iron try a few check the machine working state without abnormal again check whether parts quality standard with a first sample signature confirmation after all normal can be mass folding production and folding products neatly placed on the prepared card board.
Reasonable standard good folding machine, not only can improve the work efficiency, more can reduce unnecessary loss.
Source: http://news.naliyin.com/
